Hot Products


How To Maintain The Cutting Machine
Aug 24, 2018

1.  Replace hydraulic oil

The cycle of replacing the hydraulic oil is one year (it can be shortened or extended according to your actual use), and the fuel tank and filter are cleaned while replacing the hydraulic oil. For hydraulic oil, please select the regular brand brand product labeled 46#.

2. Clear dust

Remove dust and foreign matter should be done every day (electric dust should be handled by professionals), paying special attention to the sliding and rotating parts. Please note! Cleaning dust should be done after the machine has been completely shut down.

3. Fastening bolt

The fastening bolts are an important part of the maintenance of the cutting machine. If the loose bolts break for a long time, it will cause more problems or accidents (it is recommended to do the inspection every three months).

4. Check lubrication system

The sliding and rotating parts of the cutting machine need to be filled with lubricating oil, and good lubrication is necessary for the operation of the machine, so it is especially necessary to check the automatic lubrication system regularly.

5. Check the parallelism of the table

In fact, it is impossible to cut the die at the center of the cutting machine every time. Long-term off-center cutting will cause the parallelism of the cutting machine to deteriorate, thus accelerating the wear of the die and the pad. Regularly check the parallelism of the table top, and you can always grasp the parallelism of the table top of the cutting machine, so as to adjust the die cutting position during use, correct the unevenness, and make the cutting machine use longer, and exert the best performance.

Learn more about cutting

cutting machine machine.jpg

  • facebook