Operation:
1) When the pull-plate motor or the oil pump motor thermal overload relay is protected, press the thermal overload relay reset button to reset after troubleshooting.
2) If the "over-cut protection protection action" is used to eliminate the fault, and then press the "over-cut reset" ammonium button to reset, the buzzer stops the alarm. (If this happens frequently, the knife die you use is large and there is elastic cotton next to the knife edge, so that the setting of the die height is not set, you can increase the over-cut protection value.)
3) If the inverter is abnormal, after the cause of the fault is removed, the reset can be restarted.
