Q: How to solve common faults in leather embossing machines?
answer:
1. Check the water filter regularly;
2. If the machine is dusty, use it to dry the compressed air and carefully blow the machine clean, but the main power supply must be turned off;
Fault: Always turn off the main power supply before checking, because there are several thousand volts to tens of thousands of volts inside the machine.
Phenomenon 1: Common red light (overload light)
the reason:
A) damage to the lower mold insulation;
B) The work object, the vibrating cylinder or the upper and lower molds have dirt, dust and water to be cleaned;
C) the upper and lower molds are in poor horizontal position;
D) The upper and lower molds have no insulation and directly touch together;
E) the input power is too high;
F) the vacuum tube is damaged or loose;
G) The power supply protection electronic board is damaged, and the overcurrent protection board has the same piece of three main electrical appliances;
H) The homogenizer is too large and the output is too high;
I) The work is too large and exceeds the rated output of the same machine;
J) The temperature control part is faulty;
K) The high voltage capacitor is damaged;
L) The insulating column (upper template) is damaged.
Phenomenon 2: When the high cycle output, the total power is disconnected or the fuse is burned
the reason:
A) Vacuum tube failure
B) Transformer failure
C) High voltage rectifier board failure
D) Three-phase magnetic switch is damaged
E) High voltage line short barrier
F) Heated plate failure
Phenomenon 3: No output
the reason:
A) Poor contact of the switch
B) Line failure
C) Vacuum tube failure
Phenomenon 4: Poor work
the reason:
A) poor adjustment;
B) Mold problem
C) There is a problem with the rubber (work)
D) The insulation is too thick and the insulation is too high
Note: When the mold touches the lower mold, the grounding copper sheet must be pressed against the lower fixed plate, and the round copper piece can be slightly deformed. If the grounding copper piece is not adjusted, the machine will not work stably. This grounding copper piece needs to be re-adjusted once when the molds of different heights are replaced.
