In the special case of hydraulic cutting machine, when the upper pressure plate needs to rise immediately, press the reset button. When stopping, press the power brake button (red button), and the whole system will stop working immediately.
In order to ensure safety, it is strictly forbidden to extend the hand and other parts of the body into the punching area during operation. The power must be turned off before maintenance and the wooden block or other hard objects are placed in the blanking area to prevent the upper pressure plate from getting out of control after the pressure is released. Injury to personal injury. You must use both hands to hit the two buttons on the pressure plate during operation, and you must not change one hand or pedal operation.
The hydraulic cutting machine stacks the push-pull plate, the rubber plate, the workpiece and the die in the middle of the table. First turn the cutting depth controller (fine tuning knob) to zero. Turn on the power switch, press the oil pump start button, run for two minutes at no load, and observe if the system is normal.
