1. Turn on the main power supply (in the electric box), turn on the power emergency stop button, and power on the whole machine.
2. Press the home icon of the touch screen to go to the next page.
3. Press the “oil pump start” button on the touch screen to start the oil pump motor. At this time, the upper pressure plate of the machine will move.
Do it once and find the location of the work origin.
4. Press the “Parameter Operation (A Area Operation)” button on the touch screen to enter the working parameter screen.
5, set the die:
a. The operator places the die to be used to the center of the feeding platform. (Note: setting the die
Should not place the punched item above or below the die)
b. Press the “die setting” button on the touch screen, and the setting indicator will flash at this time.
c. Press the “pull board forward” button on the touch screen. At this time, the feeding platform will send the die into the machine.
The cutting area, and the upper platen will automatically drop until the pressing die stops.
d. After the upper platen presses the die, stop pressing the “set reset” button on the touch screen to complete the setting.
Operation, at this time, the setting indicator is off; the upper pressure plate is raised; the feeding platform is returned.
6, trial / punch:
a. The operator places the material to be punched onto the knife edge of the feeding platform;
b. Press the “upward height” and “cutting depth” buttons of the touch screen to adjust each working parameter;
Note: The value of the cutting depth value should not be too large for each increment or decrement, otherwise the knife may be crushed.
mold! ! ! After setting the die, the cutting value should be gradually increased from small to large until the punching is qualified.
c. The operator presses the two-hand operation button, and the machine enters the loading process.
d. If the punched product fails, the “cut depth” value can be modified.
